Cisco Sx350

CDP Commands
215 Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
8
Default Configuration
Enabled.
Command Mode
Global Configuration mode
User Guidelines
Use the command to delete CDP packets not including all the mandatory TLVs.
Example
This example turns off mandatory TLV validation:
switchxxxxxx(config)# no cdp mandatory-tlvs validation
8.10 cdp pdu
To specify CDP packets handling when CDP is globally disabled, use the cdp pdu
command in Global Configuration mode. To return to default, use the no form of
this command.
Syntax
cdp pdu [filtering | bridging | flooding]
no cdp pdu
Parameters
• filtering—Specify that when CDP is globally disabled, CDP packets are
filtered (deleted).
• bridging—Specify that when CDP is globally disabled, CDP packets are
bridged as regular data packets (forwarded based on VLAN).
• flooding—Specify that when CDP is globally disabled, CDP packets are
flooded to all the ports in the product that are in STP forwarding state,
ignoring the VLAN filtering rules.
Default Configuration
bridging