Cisco Sx350

System Management Commands
1187 Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
62
Examples
Example 1: The following example reloads the operating system.
switchxxxxxx> reload
This command will reset the whole system and disconnect your current session.
Do you want to continue? (y/n) [Y]
Example 2: The following example reloads the operating system in 10 minutes.
switchxxxxxx> reload in 10
This command will reset the whole system and disconnect your current session.
Reload is scheduled for 11:57:08 UTC Fri Apr 21 2012 (in 10 minutes). Do you
want to continue? (y/n) [Y]
Example 3: The following example reloads the operating system at 13:00.
switchxxxxxx> reload at 13:00
This command will reset the whole system and disconnect your current session.
Reload is scheduled for 13:00:00 UTC Fri Apr 21 2012 (in 1 hour and 3
minutes). Do you want to continue? (y/n) [Y]
Example 4: The following example cancels a reload.
switchxxxxxx> reload cancel
Reload cancelled.
62.4 resume
To enable switching to another open Telnet session, use the resume EXEC mode
command.
Syntax
resume [
connection ]