Cisco Sx350

Virtual Local Area Network (VLAN) Commands
1289 Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
67
The port association configuration for a community secondary VLAN includes:
• The port is added as untagged to the primary VLAN and to the secondary
VLAN.
• The PVID is set to the VLAN-ID of the secondary VLAN.
• The port ingress filtering is enabled.
The port association configuration for an isolated secondary VLAN includes:
• The port is added as untagged only to the primary VLAN and is not added
to the secondary VLAN.
• The PVID is set to the VLAN-ID of the secondary VLAN.
• The port ingress filtering is disabled.
Example
The following example set port gi14
to secondary VLAN 20 in primary VLAN 10.
switchxxxxxx(config)# interface gi14
switchxxxxxx(config-if)# switchport private-vlan host-association 10 20
67.34 show vlan private-vlan
Use the show vlan private-vlan EXEC mode command to display private VLAN
information.
Syntax
show vlan private-vlan
[tag vlan-id ]
Parameters
• tag vlan-id —Primary VLAN that represent the private VLAN to be displayed.
Default Configuration
All private VLANs are displayed.
Command Mode
User EXEC mode