Cisco Sx350

Route Map Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 1040
53
Example
In the following example sets IPv76 address 3003:17ac::20 as the next hop IPv6 address:
switchxxxxxx(config)# route-map pbr
switchxxxxxx(config-route-map)# match ipv6 address access-list acl1
switchxxxxxx(config-route-map)# set ipv6 next-hop 3003:17ac::20
switchxxxxxx(config-route-map)# exit
switchxxxxxx(config-ip-al)# exit
53.6 show route-map
To display route maps, use the show route-map command in Privileged EXEC
mode.
Syntax
show route-map [
map-name ]
Parameters
• map-name —Name of a specific route map.
Default Configuration
Command Mode
Privileged EXEC mode
User Guidelines
Use the show route-map
map-name command, to display one given route map.
Use the show route-map command, to display all configured route maps.
Example
The following is sample output from the show route-map command:
switchxxxxxx# show route-map