Ethernet Configuration Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 410
17
Default Configuration
None
Command Mode
Privileged EXEC mode
Example
The following example displays the Err-Disable configuration.
switchxxxxxx#
show errdisable recovery
Timer interval: 300 Seconds
Reason Automatic Recovery
---------------------- ------------------
port-security Disable
dot1x-src-address Disable
acl-deny Enable
stp-bpdu-guard Disable
stp-loopback-guard Disable
loop-detection Disable
udld Disable
storm control Disable
link-flap Disable
17.27 show errdisable interfaces
To display the Err-Disable state of all interfaces or of a specific interface, use the
show errdisable interfaces Privileged EXEC mode command.
Syntax
show errdisable interfaces
[interface-id]
To Next Page
Loading...
