Radius Server Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 992
49
Group gr1
VLAN: 124
Privilege Level: 15
Time Range: ConnectionTime
Group Users: develop, designers
Group gr2
Privilege Level: 1 (default)
Group Users: bob
49.18 show radius server rejected users
To display rejected users, use the show radius server rejected users command in
Privileged EXEC mode.
Syntax
show radius server rejected users [username
user-name
]
Parameters
•
user-name
—Specifies the user name. (Length: 1–32 characters)
Command Mode
Privileged EXEC mode
User Guidelines
The Radius server saves the last 1000 rejected authentication requests in a cycle
file on FLASH.
The Radius server saves the last 1000 accounting logs in a cycle file on FLASH.
Use the show radius server rejected users
user-name
command, to display one
rejected user.
Use the show radius server rejected users command, to display all rejected users.
To Next Page
Loading...
Need help?
General
