Cisco Sx350

System Management Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 1200
62
User Guidelines
Caution: Avoid running multiple show tech-support commands on a switch or
multiple switches on the network segment. Doing so may cause starvation of
some time sensitive protocols, like STP.
The show tech-support command may time out if the configuration file output
takes longer to display than the configured session time out time. If this happens,
enter a set logout timeout value of 0 to disable automatic disconnection of idle
sessions or enter a longer timeout value.
The show tech-support command output is continuous, meaning that it does not
display one screen at a time. To interrupt the output, press Esc.
If the user specifies the memory keyword, the show tech-support command
displays the following output:
• Flash info (dir if exists, or flash mapping)
• Output of command show bootvar
• Buffers info (like print os buff)
• Memory info (like print os mem)
• Proc info (like print OS tasks)
• Versions of software components
• Output of command show cpu utilization
62.17 show system fans
To view the status of the fans on the device, use the show system fans EXEC mode
command.
Syntax
show system fans
Command Mode
User EXEC mode
Examples