Cisco Sx350 - Show Lldp Statistics

Link Layer Discovery Protocol (LLDP) Commands
795 Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
36
36.28 show lldp statistics
To display LLDP statistics on all ports or a specific port, use the show lldp
statistics EXEC mode command.
Syntax
show lldp statistics
[interface-id | detailed ]
Parameters
• interface-id—(Optional) Specifies the port ID.
• detailed—(Optional) Displays information for non-present ports in addition
to present ports.
Default Configuration
If no port ID is entered, the command displays information for all ports. If detailed is
not used, only present ports are displayed.
Command Mode
User EXEC mode
Example
switchxxxxxx# show lldp statistics
Power priority The PD device priority. A PSE device
advertises the power priority configured for
the port. A PD device advertises the power
priority configured for the device. The
possible values are: Critical, High and Low.
Power value The total power in watts required by a PD
device from a PSE device, or the total power
a PSE device is capable of sourcing over a
maximum length cable based on its current
configuration.
LLDP MED - Location
Coordinates, Civic
address, ECS ELIN.
The location information raw data.
Field Description