Cisco Sx350

Virtual Local Area Network (VLAN) Commands
1259 Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
67
Syntax
interface range vlan
vlan-range
Parameters
• vlan-range —Specifies a list of VLANs. Separate nonconsecutive VLANs
with a comma and no spaces. Use a hyphen to designate a range of VLANs.
Default Configuration
N/A
Command Mode
Global Configuration mode
User Guidelines
Commands under the interface VLAN range context are executed independently
on each VLAN in the range. If the command returns an error on one of the VLANs,
an error message is displayed, and the system attempts to configure the
remaining VLANs.
Example
The following example groups VLANs 221 through 228 and 889 to receive the
same command(s).
switchxxxxxx(config)# interface range vlan 221-228, vlan 889
67.6 name
Use the name Interface Configuration (VLAN) mode command to name a VLAN.
Use the no form of this command to remove the VLAN name.
Syntax
name
string
no name
Parameters
• string —Specifies a unique name associated with this VLAN. (Length: 1–32
characters).