DHCPv6 Commands
361 Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
14
14.9 show ipv6 dhcp interface
To display DHCP for IPv6 interface information, use the show ipv6 dhcp interface
command in User EXEC mode.
Syntax
show ipv6 dhcp interface [
interface-id
]
Parameters
•
interface-id
—Interface identifier.
Command Mode
User EXEC mode
User Guidelines
If no interfaces are specified in the command, all interfaces on which DHCP for
IPv6 (client or server) is enabled are displayed. If an interface is specified in the
command, only information about the specified interface is displayed.
Note. It is a legacy output format supported by SW versions not supporting
statefull configuration
Example
The following is sample output from this command when only the Stateless
service is enabled:
switchxxxxxx#
show ipv6 dhcp interface
VLAN 100 is in client mode
DHCP Operational mode is enabled
Stateless Service is enabled
Reconfigure service is enabled
Information Refresh Minimum Time: 600 seconds
Information Refresh Time: 86400 seconds
Received Information Refresh Time: 3600 seconds
Remain Information Refresh Time: 411 seconds
DHCP server:
To Next Page
Loading...
Need help?
General
