Cisco Sx350

GARP VLAN Registration Protocol (GVRP) Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 456
19
switchxxxxxx(config-if)# interf ace gi13
switchxxxxxx(config-if)# gvrp vlan-creation-forbid
19.6 show gvrp configuration
To display GVRP configuration information, including timer values, whether GVRP
and dynamic VLAN creation are enabled, and which ports are running GVRP, use
the show gvrp configuration EXEC mode command.
Syntax
show gvrp configuration
[interface-id | detailed ]
Parameters
• interface-id—(Optional) Specifies an interface ID. The interface ID can be
one of the following types: Ethernet port or port-channel.
• detailed—(Optional) Displays information for non-present ports in addition
to present ports.
Default Configuration
All GVRP statistics are displayed for all interfaces. If detailed is not used, only
present ports are displayed.
Command Mode
User EXEC mode
Example
The following example displays GVRP configuration.
switchxxxxxx# show gvrp configuration
GVRP Feature is currently Enabled on the device.
Maximum VLANs: 4094
Port(s) GVRP-Status Regist- Dynamic Timers(ms)
ration VLAN Creation Join Leave Leave All
---- ----------- -------- ------------- ---- ----- ----------
gi1 1 Enabled Forbidden Disabled 600 200 10000