Cisco Sx350

IPv6 First Hop Security
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 716
29
29.81 show ipv6 source guard policy
To display IPv6 Source Guard policies, use the show ipv6 source guard policy
command in Privilege EXEC configuration mode.
Syntax
show ipv6 source guard policy [
policy-name | active]
Parameters
• policy-name —IPv6 Source Guard policy name.
• active—Displays the attached IPv6 Source Guard policies.
Command Mode
Privileged EXEC mode
User Guidelines
This command displays all configured IPv6 Source Guard policies, the given one
or all attached IPv6 Source Guard policies.
Examples
Example 1—The following example displays the policy configuration for a policy
named policy1:
switchxxxxxx# show ipv6 source guard policy policy1
Neighbor Binding Policy: policy1
trusted port: disabled
Attached to ports:
Ports
gi11-2
gi14
Po1-4
Example 2—The following example displays the attached policies: