Cisco Sx350

User Interface Commands
1241 Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
66
Syntax
enable [
privilege-level ]
Parameters
privilege-level—(Optional) Specifies the privilege level at which to enter the
system.(Range: 1,7,15)
Default Configuration
The default privilege level is 15.
Command Mode
User EXEC mode
Example
The following example enters privilege level 7.
switchxxxxxx# enable 7
enter password:**********
switchxxxxxx# Accepted
The following example enters privilege level 15.
switchxxxxxx# enable
enter password:**********
switchxxxxxx# Accepted
66.7 end
To end the current configuration session and return to the Privileged EXEC mode,
use the end command.
Syntax
end