Cisco Sx350

802.1X Commands
85 Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
3
.
3.5 dot1x auth-not-req
To enable unauthorized devices access to a VLAN, use the dot1x auth-not-req
command in Interface (VLAN) Configuration mode. To disable access to a VLAN,
use the no form of this command.
Syntax
dot1x auth-not-req
no dot1x auth-not-req
Parameters
N/A
Default Configuration
Access is enabled.
Command Mode
Interface (VLAN) Configuration mode
User Guidelines
The guest VLAN cannot be configured as unauthorized VLAN.
Example
The following example enables unauthorized devices access to VLAN 5.
switchxxxxxx(config)# interface vlan 5
switchxxxxxx(config-if)#
dot1x auth-not-req