Cisco Sx350

Quality of Service (QoS) Commands
961 Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
47
Syntax
qos statistics aggregate-policer
aggregate-policer-name
no qos statistics aggregate-policer aggregate-policer-name
Parameters
aggregate-policer-name—Specifies the aggregate policer name. (Length: 1–32
characters)
Default Configuration
Counting in-profile and out-of-profile is disabled.
Command Mode
Global Configuration mode
Example
The following example enables counting in-profile and out-of-profile on the
interface.
switchxxxxxx(config)# qos statistics aggregate-policer policer1
47.38 qos statistics queues
Use the qos statistics queues Global Configuration mode command to enable
QoS statistics for output queues. Use the no form of this command to disable QoS
statistics for output queues.
Syntax
qos statistics queues
set { queue | all} {dp | all} {interface | all}
no qos statistics queues set
Parameters
• set—Specifies the counter set number.
• interface—Specifies the Ethernet port.
• queue—Specifies the output queue number.