Cisco Sx350

Ethernet Configuration Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 402
17
gi12 1G-Copper -- -- -- -- Down -- --
Flow Link
PO Type Duplex Speed Neg control State
----- ------- ------ ----- ------- ---- ------
Po1 1G Full 10000 Disabled Off Up
*: The interface was suspended by the system.
17.21 show interfaces advertise
To display auto-negotiation advertisement information for all configured interfaces
or for a specific interface, use the show interfaces advertise Privileged EXEC
mode command.
Syntax
show interfaces advertise
[interface-id | detailed ]
Parameters
• interface-id—(Optional) Specifies an interface ID. The interface ID can be
one of the following types: Ethernet port or port-channel.
• detailed—(Optional) Displays information for non-present ports in addition
to present ports.
Default Configuration
Display for all interfaces. If detailed is not used, only present ports are displayed.
Command Mode
Privileged EXEC mode