Cisco Sx350 User Manual

48
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 965
RADIUS Commands
48.0
48.1 radius-server host
Use the radius-server host Global Configuration mode command to configure a
RADIUS server host. Use the no form of the command to delete the specified
RADIUS server host.
Syntax
radius-server host {
ip-address | hostname } [auth-port auth-port-number ]
[acct-port
acct-port-number ] [timeout timeout ] [retransmit retries ] [deadtime
deadtime
] [key key-string ] [priority priority ] [usage {login | dot1.x | all}]
encrypted radius-server host {
ip-address | hostname } [auth-port
auth-port-number
] [acct-port acct-port-number ] [timeout timeout ] [retransmit
retries
] [deadtime deadtime ] [key encrypted-key-string ] [priority priority ] [usage
{login
| dot1.x | all}]
no radius-server host {
ip-address | hostname }
Parameters
• ip-address —Specifies the RADIUS server host IP address. The IP address
can be an IPv4, IPv6 or IPv6z address.
• hostname —Specifies the RADIUS server host name. Translation to IPv4
addresses only is supported. (Length: 1–158 characters. Maximum label
length of each part of the hostname: 63 characters)
• auth-port auth-port-number —Specifies the port number for authentication
requests. If the port number is set to 0, the host is not used for
authentication. (Range: 0–65535)
• acct-port acct-port-number —Port number for accounting requests. The
host is not used for accountings if set to 0. If unspecified, the port number
defaults to 1813.
• timeout timeout —Specifies the timeout value in seconds. (Range: 1–30)

Cisco Sx350 Specifications

General

Brand	Cisco
Model	Sx350
Category	Switch
Language	English