Cisco Sx350

Radius Server Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 984
49
Use the no radius server nas secret ip-address command, to remove the given
NAS and its secret key.
Use the no radius server nas secret command, to delete all NASs and all secret
keys.
Examples
Example 1. The following example defines a default secret key:
switchxxxxxx(config)# radius server nas secret key qrBut56$#qw default
Example 2. The following example defines a default secret key:
switchxxxxxx(config)# radius server nas secret key qrBut56$#qw default
Example 3. The following example defines a NAS using the default secret key:
switchxxxxxx(config)# radius server nas secret 10.05.10.1
49.11 radius server traps accounting
To enable sending accounting traps, use the radius server traps accounting
command in Global Configuration mode. To disable the traps, use the no form of
this command.
Syntax
radius server traps accounting
no radius server traps accounting
Parameters
N/A
Default Configuration
Accounting traps are disabled.