Quality of Service (QoS) Commands
925 Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
47
Parameters
policy-map-name—Specifies the policy map name. (Length: 1–32 characters)
Default Configuration
All policy-maps are displayed.
Command Mode
Privileged EXEC mode
Example
The following example displays all policy maps.
switchxxxxxx(config)#
show policy-map
Policy Map policy1
class class1
set dscp 7
Policy Map policy2
class class 2
police 96000 4800 exceed-action drop
class class2
redirect gi12
class class 3
police 96000 4800 exceed-action policed-dscp-transmit peak 128000 9600
violate-action policed-dscp-transmit
47.10 trust
Use the trust Policy-map Class Configuration mode. command to configure the
trust state. Use the no form of this command to return to the default trust state.
Syntax
trust
no trust
To Next Page
Loading...
