Cisco Sx350

DHCP Server Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 310
12
The following table describes the significant fields shown in the display.
12.22 show ip dhcp binding
To display the specific address binding or all the address bindings on the DHCP
server, use the show ip dhcp binding command in User EXEC mode.
Syntax
show ip dhcp binding
[ ip-address ]
Parameters
• ip-address —(Optional) Specifies the IP address.
Command Mode
User EXEC mode
Examples
The following examples display the DHCP server binding address parameters.
switchxxxxxx# show ip dhcp binding
DHCP server enabled
The number of used (all types) entries is 6
The number of pre-allocated entries is 1
The number of allocated entries is 1
The number of expired entries is 1
Field Description
IP address The host IP address as recorded on the DHCP
Server.
Hardware
address
The MAC address or client identifier of the host as
recorded on the DHCP Server.
Lease
expiration
The lease expiration date of the host IP address.
Type The manner in which the IP address was assigned
to the host.