Cisco Sx350

802.1X Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 110
3
User Guidelines
The traps are sent after the client is set to the quiet state after the maximum
sequential attempts of login.
The command is only applied to the web-based authentication.
A rate limit is applied to the traps: not more than one trap of this type can be sent in 10
seconds.
Example
The following example enables sending traps when a host is set in the quiet state:
switchxxxxxx(config)# dot1x traps authentication quiet
3.28 dot1x traps authentication success
To enable sending traps when a host is successfully authorized by an 802.1X
authentication method, use the dot1x traps authentication success command in
Global Configuration mode. To disable the traps, use the no form of this command.
Syntax
dot1x traps authentication success {[802.1x] [mac] [web]}
no dot1x traps authentication success
Parameters
• 802.1x—Enables traps for 802.1X-based authentication.
• mac—Enables traps for MAC-based authentication.
• web—Enables traps for WEB-based authentication.
Default Configuration
Success traps are disabled.
Command Mode
Global Configuration mode