Cisco Sx350

Radius Server Commands
979 Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
49
Example
The following example specified privilege level 15 for users of the developers
group:
switchxxxxxx(config)# radius server group developers
switchxxxxxx(config-radser-group)# privilege-level 15
switchxxxxxx(config-radser-group)# exit
switchxxxxxx(config)#
49.6 radius server accounting-port
To define the accounting UDP port used for accounting requests, use the radius
server accounting-port command in Global Configuration mode. To restore the
default configuration, use the no form of this command.
Syntax
radius server accounting-port
udp-port
no radius server accounting-port
Parameters
• udp-port —Specifies the UDP port number for accounting requests. (Range:
1–65535)
Default Configuration
1813
Command Mode
Global Configuration mode
User Guidelines
Use the radius server accounting-port command, to define an UDP port for
accounting requests.
Use the no radius server accounting-port command, to restore the default UDP
accounting port.