Cisco Sx350

Line Commands
753 Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
34
Default Configuration
The default speed is 115200 bps.
Command Mode
Line Configuration Mode
User Guidelines
The configured speed is only applied when autobaud is disabled. This
configuration applies to the current session only.
Example
The following example configures the line baud rate as 9600 bits per second.
switchxxxxxx(config-line)# speed 9600
34.5 show line
To display line parameters, use the show line Privileged EXEC mode command.
Syntax
show line
[ console | telnet | ssh]
Parameters
• console—(Optional) Displays the console configuration.
• telnet—(Optional) Displays the Telnet configuration.
• ssh—(Optional) Displays the SSH configuration.
Default Configuration
If the line is not specified, all line configuration parameters are displayed.
Command Mode
Privileged EXEC mode