Cisco Sx350

IP Addressing Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 512
24
no ip proxy-arp
Default Configuration
ARP Proxy is disabled.
Command Mode
Interface Configuration mode
User Guidelines
This configuration can be applied only if at least one IP address is defined on a
specific interface.
The command is supported only when IP Routing is enabled.
Example
The following example enables ARP proxy when the switch is in router mode.
switchxxxxxx(config-if)# ip proxy-arp
24.10 clear arp-cache
Use the clear arp-cache Privileged EXEC mode command to delete all dynamic
entries from the ARP cache.
Syntax
clear arp-cache
Command Mode
Privileged EXEC mode
Example
The following example deletes all dynamic entries from the ARP cache.
switchxxxxxx# clear arp-cache