Cisco Sx350

IGMP Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 468
21
Configuration mode. To restore the default IGMP query interval, use the no form of
this command.
Syntax
ip igmp last-member-query-interval
milliseconds
no ip igmp last-member-query-interval
Parameters
• milliseconds —Interval, in milliseconds, at which IGMP group-specific host
query messages are sent on the interface. (Range: 100–25500).
Default Configuration
The default IGMP last member query interval is 1000 milliseconds.
Command Mode
Interface Configuration mode
User Guidelines
Use the ip igmp last-member-query-interval command to configure the IGMP last
member query interval on an interface.
Example
The following example shows how to increase the the IGMP last member query
interval to 1500 milliseconds:
switchxxxxxx(config)# interface vlan 100
switchxxxxxx(config-if)# ip igmp last-member-query-interval 1500
switchxxxxxx(config-if)# exit
21.4 ip igmp query-interval
To configure the frequency at which the IGMP querier sends Internet Group
Management Protocol (IGMP) host-query messages from an interface, use the ip
igmp query-interval command in Interface Configuration mode. To restore the
default IGMP query interval, use the no form of this command.