iSCSI QoS Commands
737 Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
32
Example
The following example enables iSCSI QoS globally:
switchxxxxxx(config)#
iscsi enable
32.2 iscsi flow
To define an iSCSI flow, use the iscsi flow command in Global Configuration mode.
To remove the iSCSI flow, use the no form of the command.
Syntax
iscsi flow default | {
tcp-port
[
ip-address
]}
no iscsi flow [default | {
tcp-port
[
ip-address
]}]
Parameters
•
default—Restores the default IPv4 flows.
•
tcp-port
—Specifies the TCP port number on which iSCSI targets listen to
requests. (Range: 1–65535)
•
ip-address
—Specifies the IPv4 address on which iSCSI targets listen to
requests.
Default Configuration
Two iSCSI IPv4 flows with well-known TCP ports 3260 and 860.
Command Mode
Global Configuration mode
User Guidelines
Each iscsi flow command defines an iSCSI flow including the following two
sub-flows:
To Next Page
Loading...
