Cisco Sx350

SYSLOG Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 1178
61
61.13 logging aggregation aging-time
To configure the aging time of the aggregated SYSLOG messages, use the
logging aggregation aging-time Global Configuration mode command. The
SYSLOG messages are aggregated during the time interval set by the aging-time
parameter. To return to the default, use the no form of this command.
Syntax
logging aggregation aging-time
sec
no logging aggregation aging-time
Parameters
aging-time
sec —Aging time in seconds (Range: 15–3600)
Default Configuration
300 seconds.
Command Mode
Global Configuration mode
Example
switchxxxxxx(config)# logging aggregation aging-time 300
61.14 logging origin-id
To configure the origin field of the SYSLOG message packet headers sent to the
SYSLOG server, use the logging origin-id Global Configuration mode command.
To return to the default, use the no form of this command.
Syntax
logging origin-id {
hostname | IP | IPv6 | string user-defined-id }
no logging origin-id