SYSLOG Commands
1177 Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
61
Example
The following example configures the VLAN 10 as the source interface.
switchxxxxxx(config)#
logging source-interface-ipv6 vlan 100
61.12 logging aggregation on
To control aggregation of SYSLOG messages, use the logging aggregation on
Global Configuration mode command. If aggregation is enabled, logging
messages are displayed every time interval (according to the aging time specified
by logging aggregation aging-time). To disable aggregation of SYSLOG
messages, use the no form of this command.
Syntax
logging aggregation on
no logging aggregation on
Parameters
This command has no arguments or keywords.
Default Configuration
Disabled
Command Mode
Global Configuration mode
Example
To turn off aggregation of SYSLOG messages:
switchxxxxxx(config)#
no logging aggregation on
To Next Page
Loading...
