File System Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 420
18
dat/file.txt
Example 6. The following example specifies a file using the higher directory:
../dat/file.txt
Example 7. The following example specifies a file on mass-storage device
connected to the USB port:
usb://aaa/dat/file.txt
Example 8. The following example specifies files on mass-storage device
connected to the USB port using the current directory:
usb:aaa/dat/file.txt
usb:./aaa/dat/file.txt
Example 9. The following example specifies a file on mass-storage device
connected to the USB port using the higher directory:
usb:../aaa/dat/file.txt
18.2 System Flash Files
The system files used by the switch are in the flash://system/ directory. A user
cannot add, delete, and rename the system files and directories, a user cannot
create new directories under the system directory.
The system files are divided to the following groups:
• Inner System files. The files are created by the switch itself. For example the
Syslog file.
• Files installed/Uninstalled by user. This group includes the following files:
To Next Page
Loading...
