Cisco Sx350

Address Table Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 170
4
The actions define by this command has precedence over forwarding rules
defined by applications/protocols (STP, LLDP etc.) supported on the device.
Example
switchxxxxxx(config)# bridge multicast reserved-address 00:3f:bd:45:5a:b1
4.35 show bridge multicast
reserved-addresses
To display the Multicast reserved-address rules, use the show bridge multicast
reserved-addresses Privileged EXEC mode command.
Syntax
show bridge multicast reserved-addresses
Command Mode
Privileged EXEC mode
Example
switchxxxxxx # show bridge multicast reserved-addresses
MAC Address Frame Type Protocol Action
------------------ ----------- -------------- ------------
01-80-C2-00-00-00 LLC-SNAP 00-00-0C-01-29 Bridge