Cisco Sx350

Clock Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 252
9
• time-b.timefreq.bldrdoc.gov
• time-c.timefreq.bldrdoc.gov
Command Mode
Global Configuration mode
User Guidelines
Use the sntp server {
ip-address | hostname } [poll] [key keyid ] command to define a
SNTP server. The switch supports up to 8 SNTP servers.
Use the sntp server default command to return to the default configuration.
Use the no sntp server
ip-address | hostname command to remove one SNTP
server.
Use the no sntp server to remove all SNTP servers.
Example
The following example configures the device to accept SNTP traffic from the
server on 192.1.1.1 with polling.
switchxxxxxx(config)# sntp server 192.1.1.1 poll
9.15 sntp source-interface
To specify the source interface whose IPv4 address will be used as the source
IPv4 address for communication with IPv4 SNTP servers, use the sntp
source-interface command in Global Configuration mode. To restore the default
configuration, use the no form of this command.
Syntax
sntp source-interface
interface-id
no sntp source-interface
Parameters
• interface-id —Specifies the source interface.