Cisco Sx350 User Manual

31
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 727
IPv6 Prefix List Commands
31.0
31.1 clear ipv6 prefix-list
Use the clear ipv6 prefix-list command in privileged EXEC mode to reset the hit
count of the IPv6 prefix list entries.
Syntax
clear ipv6 prefix-list [
prefix-list-name [ ipv6-prefix / prefix-length ]]
Parameters
• prefix-list-name —The name of the prefix list from which the hit count is to
be cleared.
• ipv6-prefix —The IPv6 network from which the hit count is to be cleared.
This argument must be in the form documented in RFC 4293 where the
address is specified in hexadecimal using 16-bit values between colons.
• / prefix-length —The length of the IPv6 prefix. A decimal value that indicates
how many of the high-order contiguous bits of the address comprise the
prefix (the network portion of the address). A slash mark must precede the
decimal value.
Default Configuration
The hit count is automatically cleared for all IPv6 prefix lists.
Command Mode
Privileged EXEC mode
User Guidelines
The hit count is a value indicating the number of matches to a specific prefix list
entry.

Cisco Sx350 Specifications

General

Brand	Cisco
Model	Sx350
Category	Switch
Language	English