Cisco Sx350

Clock Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 246
9
Syntax
sntp anycast client enable [both | ipv4 | ipv6]
Parameters
• both—(Optional) Specifies the IPv4 and IPv6 SNTP Anycast clients are
enabled. If the parameter is not defined it is the default value.
• ipv4—(Optional) Specifies the IPv4 SNTP Anycast clients are enabled.
• ipv6—(Optional) Specifies the IPv6 SNTP Anycast clients are enabled.
Default Configuration
The SNTP anycast client is disabled.
Command Mode
Global Configuration mode
User Guidelines
Use this command to enable the SNTP Anycast client.
Example
The following example enables SNTP Anycast clients.
switchxxxxxx(config)# sntp anycast client enable
9.9 sntp authenticate
To enable authentication for received SNTP traffic from servers, use the sntp
authenticate command in Global Configuration mode. To restore the default
configuration, use the no form of this command.
Syntax
sntp authenticate
no sntp authenticate