Cisco Sx350 User Manual

Ethernet Configuration Commands
389 Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
17
Command Mode
Interface (Ethernet) Configuration mode
Example
The following example configures gi11 to operate in full duplex mode.
switchxxxxxx(config)# interface gi11
switchxxxxxx(config-if)# duplex full
17.8 negotiation
To enable auto-negotiation operation for the speed and duplex parameters and
master-slave mode of a given interface, use the negotiation Interface (Ethernet,
Port Channel) Configuration mode command. To disable auto-negotiation, use the
no form of this command.
Syntax
negotiation [
capability [ capability2 ... capability5 ]] [ preferred { master | slave }]
no negotiation
Parameters
• Capability—(Optional) Specifies the capabilities to advertise. (Possible
values: 10h, 10f, 100h,100f, 1000f ).
- 10h—Advertise 10 half-duplex
- 10f—Advertise 10 full-duplex
- 100h—Advertise 100 half-duplex
- 100f—Advertise 100 full-duplex
- 1000f—Advertise 1000 full-duplex
• Preferred—(Optional) Specifies the master-slave preference:
- Master—Advertise master preference
- Slave—Advertise slave preference

Cisco Sx350 Specifications

General

Brand	Cisco
Model	Sx350
Category	Switch
Language	English