Cisco Sx350

DHCPv6 Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 354
14
ipv6 dhcp duid-en 9 0CC084D303000912
Example 2. The following sets the DIID-EN format using colons as delimiter:
switchxxxxxx(config)# ipv6 dhcp duid-en 9 0C:C0:84:D3:03:00:09:12
14.6 ipv6 dhcp relay destination (Global)
To specify a globally-defined relay destination address to which client messages
are forwarded, use the ipv6 dhcp relay destination command in Global
Configuration mode. To remove a relay destination address, use the no form of this
command.
Syntax
ipv6 dhcp relay destination {
ipv6-address [ interface-id ]} | interface-id
no ipv6 dhcp relay destination [{ ipv6-address [ interface-id ]} | interface-id ]
Parameters
• ipv6-address [ interface-id ]—Relay destination IPv6 address in the form
documented in RFC 4291 where the address is specified in hexadecimal
using 16-bit values between colons. There are the following types of relay
destination address:
- Link-local Unicast address. A user must specify the interface-id
argument for this kind of address.
- Global Unicast IPv6 address. If the interface-id argument is omitted then
the Routing table is used.
• interface-id —Interface identifier that specifies the output interface for a
destination. If this argument is configured, client messages are forwarded to
the well-known link-local Multicast address
All_DHCP_Relay_Agents_and_Servers (FF02::1:2) through the link to which
the output interface is connected.
Default Configuration
There is no globally-defined relay destination.