Cisco Sx350 - 65 UDLD Commands; Show Udld

65
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 1227
UDLD Commands
65.0
65.1 show udld
To display the administrative and operational Unidirectional Link Detection
Protocol (UDLD) status, use the show udld command in Privileged EXEC mode.
Syntax
show udld [
interface-id ] [neighbors]
Parameters
• interface-id —Interface identifier of an Ethernet port.
• neighbors—Displays neighbor information only.
Command Mode
Privileged EXEC mode
User Guidelines
If you do not enter an interface ID value, the administrative and operational UDLD
status for all interfaces on which UDLD is enabled are displayed.
Examples
Example 1—This example shows how to display the UDLD state for all interfaces.
Most of the fields shown in the display are self-explanatory. Those that are not
self-explanatory are defined below.
switchxxxxxx# show udld
Global UDLD mode: normal
Message Time: 15 sec(default)
Interface
gi1 1
Port UDLD mode: aggressive
Port Current state: Bidirectional