Cisco Sx350

Auto-Update and Auto-Configuration
197 Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
6
Examples
Example 1. The following example specifies the auto mode and specifies "scon" as
the SCP extension:
switchxxxxxx(config)# boot host auto-config auto scon
Example 2. The following example specifies the auto mode and does not provide
an SCP extension.
In this case "scp" is used.
switchxxxxxx(config)# boot host auto-config auto
Example 3. The following example specifies that only the SCP protocol will be
used:
switchxxxxxx(config)# boot host auto-config scp
6.2 boot host auto-update
Use the boot host auto-update Global Configuration mode command to enable the
support of auto update via DHCP. Use the no form of this command to disable
DHCP auto configuration.
Syntax
boot host auto-update [tftp | scp | auto [
extension ]]
no boot host auto-update
Parameters
• tftp—Only the TFTP protocol is used by auto-update.
• scp—Only the SCP protocol is used by auto-update.
• auto (Default)—Auto-configuration uses the TFTP or SCP protocol
depending on the Indirect image file's extension. If this option is selected,
the extension parameter may be specified or, if not, the default extension is
used.