Cisco Sx350

DHCP Relay Commands
285 Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
11
11.5 show ip dhcp relay
Use the show ip dhcp relay EXEC mode command to display the DHCP relay
information.
Syntax
show ip dhcp relay
Command Mode
User EXEC mode
Examples
Example 1. Option 82 is not supported:
switchxxxxxx# show ip dhcp relay
DHCP relay is globally enabled
Option 82 is Disabled
Maximum number of supported VLANs without IP Address is 256
Number of DHCP Relays enabled on VLANs without IP Address is 0
DHCP relay is not configured on any port.
DHCP relay is not configured on any vlan.
No servers configured
Example 2. Option 82 is supported (disabled):
switchxxxxxx# show ip dhcp relay
DHCP relay is globally disabled
Option 82 is disabled
Maximum number of supported VLANs without IP Address: 0
Number of DHCP Relays enabled on VLANs without IP Address: 4
DHCP relay is enabled on Ports: gi11,po1-2
Active:
Inactive: gi11, po1-4