Cisco Sx350 - Show Ip Igmp Counters

IGMP Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 472
21
Syntax
ip igmp version {1 | 2 | 3}
no ip igmp version
Parameters
• 1—IGMP Version 1.
• 2—IGMP Version 2.
• 3—IGMP Version 3.
Default Configuration
3
Command Mode
Interface Configuration mode
User Guidelines
Use the commnad to change the default version of IGMP>
Example
The following example configures the router to use IGMP Version 2:
switchxxxxxx(config)# interface vlan 100
switchxxxxxx(config-if)# ip igmp version 2
switchxxxxxx(config-if)# exit
21.8 show ip igmp counters
To display the Internet Group Management Protocol (IGMP) traffic counters, use
the show ip igmp counters command in User EXEC mode.
Syntax
show ip igmp counters [
interface-id ]