System Management Commands
1189 Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
62
User Guidelines
Use the service cpu utilization command to measure information on CPU
utilization.
Example
The following example enables measuring CPU utilization.
switchxxxxxx(config)#
service cpu-utilization
62.6 show cpu input rate
To display the rate of input frames to the CPU in packets per seconds (pps), use
the show cpu input rate EXEC mode command.
Syntax
show cpu input rate
Parameters
This command has no arguments or keywords.
Command Mode
User EXEC mode
Example
The following example displays CPU input rate information.
switchxxxxxx> show cpu input rate
Input Rate to CPU is 1030 pps.
62.7 show cpu utilization
To display information about CPU utilization, use the show cpu utilization
Privileged EXEC mode command.