Cisco Sx350 User Manual

IPv6 Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 564
28
Example
The following example enables the advertisement interval option to be sent in
RAs:
switchxxxxxx(config)# interface vlan 1
switchxxxxxx(config-if)#
ipv6 nd advertisement-interval
switchxxxxxx(config-if)# exit
28.13 ipv6 nd dad attempts
Use the ipv6 nd dad attempts command in Interface Configuration mode to
configure the number of consecutive neighbor solicitation messages that are sent
on an interface while duplicate address detection is performed on the Unicast
IPv6 addresses of the interface.
To return the number of messages to the default value, use the no form of this
command.
Syntax
ipv6 nd dad attempts
value
no ipv6 nd dad attempts
Parameters
• value —The number of neighbor solicitation messages. The acceptable
range is from 0 to 600. Configuring a value of 0 disables duplicate address
detection processing on the specified interface; a value of 1 configures a
single transmission without follow-up transmissions.
Default Configuration
1
Command Mode
Interface Configuration mode

Cisco Sx350 Specifications

General

Brand	Cisco
Model	Sx350
Category	Switch
Language	English