Cisco Sx350

802.1X Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 104
3
no dot1x timeout reauth-period
Parameters
• reauth-period seconds —Number of seconds between re-authentication
attempts. (Range: 300-4294967295).
Default Configuration
3600
Command Mode
Interface (Ethernet) Configuration mode
User Guidelines
The command is only applied to the 802.1x authentication method.
Example
switchxxxxxx(config)# interface gi11
switchxxxxxx(config-if)# dot1x timeout reauth-period 5000
3.22 dot1x timeout server-timeout
To set the time interval during which the device waits for a response from the
authentication server, use the dot1x timeout server-timeout command in Interface
Configuration mode. To restore the default configuration, use the no form of this
command.
Syntax
dot1x timeout server-timeout
seconds
no dot1x timeout server-timeout
Parameters
• server-timeout seconds —Specifies the time interval in seconds during
which the device waits for a response from the authentication server.
(Range: 1–65535 seconds).