Cisco Sx350

Radius Server Commands
999 Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
49
Group: developers
Password’s MD5: 1238af77aaca17568f1298cced1255cc
49.22 vlan
To define Radius Assigned VLAN, use the vlan command in Radius Server Group
Configuration mode. To restore the default configuration, use the no form of this
command.
Syntax
vlan {id
vlan-id | name vlan-name }
no vlan
Parameters
• vlan-id —Specifies a VLAN ID. (Range: 1-4094)
• vlan-name —Specifies a name of the VLAN. (Length: 1–32characters)
Default Configuration
No Radius Assigned VLAN.
Command Mode
Radius Server Group Configuration mode
User Guidelines
Use the vlan command, to assign the VLAN to a radius client. This Radius Assigned
VLAN is passed to a Radius client in the Access-Accept message in the following
attributes:
• Tunnel-Type(64)
• Tunnel-Medium-Type(65)
• Tunnel-Private-Group-ID(81)
If a VLAN is not assigned these attributes are not included in the Access-Accept
message.
Use the no form of the command, to delete VLAN assignment.