Cisco Sx350

Virtual Local Area Network (VLAN) Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 1260
67
Default Configuration
No name is defined.
Command Mode
Interface (VLAN) Configuration mode
User Guidelines
The VLAN name must be unique.
Example
The following example assigns VLAN 19 the name Marketing.
switchxxxxxx(config)# interface vlan 19
switchxxxxxx(config-if)#
name Marketing
67.7 switchport protected-port
Use the switchport protected-port Interface Configuration mode command to
isolate Unicast, Multicast, and Broadcast traffic at Layer 2 from other protected
ports on the same switch. Use the no form of this command to disable protection
on the port.
Syntax
switchport protected-port
no switchport protected-port
Parameters
N/A
Default Configuration
Unprotected
Command Mode
Interface (Ethernet, Port Channel) Configuration mode
User Guidelines
Note that packets are subject to all filtering rules and Filtering Database (FDB)
decisions.