Cisco Sx350

IGMP Commands
471 Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
21
21.6 ip igmp robustness
To configure the Internet Group Management Protocol (IGMP) robustness variable,
use the ip igmp robustness command in Interface Configuration mode. To restore
the default value, use the no form of this command.
Syntax
ip igmp robustness
count
no ip igmp robustness
Parameters
• count —The number of expected packet loss on a link. Parameter range.
(Range: 1–7).
Default Configuration
The default value is 2.
Command Mode
Interface Configuration mode
User Guidelines
Use the ip igmp robustness command to change the IGMP robustness variable.
Example
The following example changes a value of the IGMP robustness variable to 3:
switchxxxxxx(config)# interface vlan 1
switchxxxxxx(config-if)# ip igmp robustness 3
switchxxxxxx(config-if)# exit
21.7 ip igmp version
To configure which version of Internet Group Management Protocol (IGMP) the
router uses, use the ip igmp version command in Interface Configuration mode. To
restore the default value, use the no form of this command.