Cisco Sx350

802.1X Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 86
3
3.6 dot1x authentication
To enable authentication methods on a port, use the dot1x authentication
command in Interface Configuration mode. To restore the default configuration,
use the no form of this command.
Syntax
dot1x authentication [802.1x] [mac] [web]
no dot1x authentication
Parameters
• 802.1x—Enables authentication based on 802.1X (802.1X-based
authentication).
• mac—Enables authentication based on the station's MAC address
(MAC-Based authentication).
• web—Enables WEB-Based authentication.
Default Configuration
802.1X-Based authentication is enabled.
Command Mode
Interface (Ethernet) Configuration mode
User Guidelines
Static MAC addresses cannot be authorized by the MAC-based method.
It is not recommended to change a dynamic MAC address to a static one or delete
it if the MAC address was authorized by the MAC-based authentication:
a. If a dynamic MAC address authenticated by MAC-based authentication is
changed to a static one, it will not be manually re-authenticated.
b. Removing a dynamic MAC address authenticated by the MAC-based
authentication causes its re-authentication.