Cisco Sx350

MLD Commands
825 Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
40
40.3 ipv6 mld last-member-query-interval
To configure the Multicast Listener Discovery (MLD) last member query interval,
use the ipv6 mld last-member-query-interval command in Interface Configuration
mode. To restore the default MLD query interval, use the no form of this command.
Syntax
ipv6 mld last-member-query-interval
milliseconds
no ipv6 mld last-member-query-interval
Parameters
• milliseconds —Interval, in milliseconds, at which MLD group-specific host
query messages are sent on the interface. (Range: 100–25500).
Default Configuration
The default MLD last member query interval is 1000 milliseconds.
Command Mode
Interface Configuration mode
User Guidelines
Use the ipv6 mld last-member-query-interval command to configure the MLD last
member query interval on an interface.
Example
The following example shows how to increase the MLD last member query
interval to 1500 milliseconds:
switchxxxxxx(config)# interface vlan 100
switchxxxxxx(config-if)# ipv6 mld last-member-query-interval 1500
switchxxxxxx(config-if)# exit
40.4 ipv6 mld query-interval
To configure the frequency at which the switch sends Multicast Listener Discovery
(MLD) host-query messages, use the ipv6 mld query-interval command in