Cisco Sx350 User Manual

Power over Ethernet (PoE) Commands
897 Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
45
Command Mode
Interface (Ethernet) Configuration mode
User Guidelines
The operational power limit is the minimum of the configured power limit value
and the maximum power capability on port. For example, if the configured value is
higher than 15.4W on a PoE port, the operational power limit is 15.4W.
Example
The following example sets inline power on a port.
switchxxxxxx(config)# interface gi1 1
switchxxxxxx(config-if)# power inline limit 2222
45.9 power inline limit-mode
To set the power limit mode of the system, use the power inline limit-mode Global
Configuration mode command. To return to default, use the no form of this
command.
Syntax
power inline limit-mode
{class | port }
no power inline limit-mode
Parameters
• class—The power limit of a port is based on the class of the PD (Power
Device) as detected during the classification process
• port—The power limit of a port is fixed regardless of the class of the
discovered PD.
Default Configuration
The default value is class
Command Mode
Global Configuration mode

Cisco Sx350 Specifications

General

Brand	Cisco
Model	Sx350
Category	Switch
Language	English