Cisco Sx350

IPv6 First Hop Security
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 650
29
switchxxxxxx(config-if)# ipv6 nd raguard attach-policy policy1 vlan 1-10,12-20
switchxxxxxx(config-if)# exit
Example 3—In the following example, the RA Guard policy policy1 is attached to
the gi11 port and applied to VLANs 1-10 and the RA Guard policy policy2 is
attached to the gi11 port and applied to VLANs 12-20:
switchxxxxxx(config)# interface gi11
switchxxxxxx(config-if)# ipv6 nd raguard attach-policy policy1 vlan 1-10
switchxxxxxx(config-if)# ipv6 nd raguard attach-policy policy2 vlan 12-20
switchxxxxxx(config-if)# exit
Example 4—In the following example RA Guard detaches policy policy1 from the
gi11 port:
switchxxxxxx(config)# interface gi11
switchxxxxxx(config-if)# no ipv6 nd raguard attach-policy policy1
switchxxxxxx(config-if)# exit
29.32 ipv6 nd raguard attach-policy (VLAN
mode)
To attach an RA Guard policy to a specified VLAN, use the ipv6 nd raguard
attach-policy command in VLAN Configuration mode. To return to the default, use
the no form of this command.
Syntax
ipv6 nd raguard attach-policy
policy-name
no ipv6 nd raguard attach-policy
Parameters
• policy-name —The RA Guard policy name (up to 32 characters).