Cisco Sx350 User Manual

Quality of Service (QoS) Commands
951 Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
47
• dscp-list —Specifies up to 8 DSCP values, separated by spaces. (Range: 0–
63)
• dscp-mark-down —Specifies the DSCP value to mark down. (Range: 0–63)
Default Configuration
The default map is the Null map, which means that each incoming DSCP value is
mapped to the same DSCP value.
Command Mode
Global Configuration mode
User Guidelines
The original DSCP value and policed-DSCP value must be mapped to the same
queue in order to prevent reordering.
Example
The following example marks incoming DSCP value 3 as DSCP value 5 on the
policed-DSCP map.
switchxxxxxx(config)# qos map policed-dscp 3 to 5
47.28 qos map dscp-queue
Use the qos map dscp-queue Global Configuration mode command to configure
the DSCP to queue map. Use the no form of this command to restore the default
configuration.
Syntax
qos map dscp-queue
dscp-list to queue-id
no qos map dscp-queue [ dscp-list ]
Parameters
• dscp-list—Specifies up to 8 DSCP values, separated by spaces. (Range: 0–
63)

Cisco Sx350 Specifications

General

Brand	Cisco
Model	Sx350
Category	Switch
Language	English